[Z60 Ultra Roller Complete] Mova Z60 leaking clean water

1667 6

Reading Mode

I bought a Mova Z60 a few days ago. It worked perfectly until yesterday, when it started leaking some clean water drops randomly during the cleaning process. Is there anything I should check out?

Thanks in advance

Translate

Direct to the Floor
6 Comment

JMova

I would try to lower wetness level

2025-10-29 15:34:09 Translate View Original Text

Mova Support

Hello,

This may be due to residual water from the robot's water inlet dripping during its operation after it returned to the base station to refill.

When the robot crosses obstacles or steps, the wheels may not rotate, causing water in the guide channel to drip due to the bumps and not be promptly sucked into the wastewater tank. This could also occur.

If the water continues to drip, you need to check if the wastewater tank is full.

2025-10-30 11:30:39 GB Translate View Original Text

Mova Support

Please check whether the sealing ring between the small waste water tank and the robot is intact. You can remove the waste water tank, clean the bottom area, then reinstall it properly and try again.

2025-12-26 09:59 GB Translate

Mova Support

Hello, This issue may be caused by water not being discharged from the robot's small waste water tank in time, resulting in leakage from the bottom.

2025-12-26 09:59 GB Translate

RN221046

Hi Mova, your suggestion is not the cause of the continued water drops. The mop roller is excessively wet when it leaves the dock are returning mid cleaning. research suggests there is something wrong

2025-12-22 05:24 DE Translate

CK847446

I have the same issue. After the mova refil water from the station the water drop everywhere in the house

2025-11-14 21:54:31 Translate View Original Text

Cristiano

UID:CJ142434

1Posts
0Friends

[Z60 Ultra Roller Complete] Mova Z60 leaking clean water

Direct to the Floor 6 Comment

Viewed Sections

Direct to the Floor
6 Comment