Paving stones

Just installed and all is well but my ViAX can’t get past my paving stones.  They are pretty small but it sees them as obstacles.  Any plans to be able to select obstacles on the map and say “ignore”.  I’ve managed to overcome it by creating two zones but it means I have to manually strim around the sunken paving stones which really spoils the point of a robot lawn mower.  There is also a 30 cm strip next to the stones that doesn’t get cut at all as it’s too small to be a zone.  Rather annoying

TranslateView Original Text

Good morning, thank you very much for your feedback. Regarding your issue, it is not yet possible to directly set the stone‑detected obstacle areas on the map as passable zones. For the 30‑centimeter narrow grass strip, you can use manual mode to finish mowing this section. We hope this information will be helpful to you. Please feel free to reach out to us if you have any further questions.