LDS on Z60 Ultra Complete not moving back up

Hello,

I am having severe issues with my Z60 robot. Every time he tries to clean under my bed and lowers down the LDS, it does not move back up, until the task is finished. However the robot usually doesnt get to finishing the task because once the LDS is lowered it only takes minutes for him to get lost and completely drive off the map he perfectly created before. Then he continues to drive around aimlessly.

The exact problem is already stated in another post here:
https://forum.mova-tech.com/forum.php?mod=viewthread&tid=3848

However there does not seem to be a fix for it. Does anyone know what to do?
LDS can be lowered and lifted manually. No issues when I turn off the lowering of the LDS, however it either doesnt drive under the bed then or else gets stuck because of the low height.

TranslateView Original Text

Hello,

When the LDS auto-lifting function is enabled, the robot will first clean open areas and then lower the LDS to clean low-clearance spaces.

Therefore, during cleaning in low areas, the LDS will remain lowered and will not lift up. This is expected behavior and not a malfunction.

You could try designating the area under the bed as a separate zone and then assigning a robot to clean that area. See if that improves the situation.

Okay I get that, still the robot does never make it back to the station without the LDS on. It always gets lost and basically "drives off the map" at some point

Just tried it again today with regions set as the support described. Yeah the robot went under the bed once, than thought it was still under the bed after driving off to the other side of the room. On the map it was under the bed while in reality it was like 4m away from it.